Medidas de concreto sin estrés.

Choosing the Right Slab Thickness

Getting thickness right is the single most important decision in any concrete project. A slab that is too thin cracks within a few years. A slab that is thicker than needed wastes hundreds of dollars. For sidewalks and patios that carry only foot traffic, 4 inches is the residential standard and has been for decades. Driveways need 4 to 5 inches: use 4 inches if only passenger cars will park there, and step up to 5 inches for anything heavier. Garage floors that hold vehicles plus storage should be 5 to 6 inches. Hot tub and spa pads need a full 6 inches with steel reinforcement because a filled hot tub can weigh over 4,000 pounds concentrated on a small footprint. Footings and foundations go much deeper, typically 12 to 36 inches depending on frost line and load requirements in your area.

How Much Extra to Order: The Waste Factor

Every concrete project needs a waste factor because real-world pouring never matches the math perfectly. Forms bow outward under the weight of wet concrete. Subgrade is never perfectly level. Some concrete always sticks to the mixer, the wheelbarrow, and your boots. For a straightforward rectangular slab on well-prepared subgrade, add 10% to your calculated volume. That is the industry standard and it covers nearly all residential work. Drop to 5% only for simple shapes poured by experienced crews on laser-leveled subgrade. Bump to 15% for irregular shapes, sloped sites, or deep footings where over-excavation is common. Running short mid-pour is far worse than having a little extra: it creates cold joints where the two batches meet, and those joints are permanent weak points.

Bags vs Ready-Mix: The Break-Even Math

The bags versus ready-mix decision comes down to project size. For anything under 1 cubic yard (roughly 45 bags of 80 lb mix), bags are the practical choice. You avoid delivery minimums and short-load fees, and you can work at your own pace. Between 1 and 2 cubic yards, do the math both ways: 60 to 90 bags is an enormous amount of manual mixing, and a short-load delivery fee of $50 to $150 might still beat the labor. Above 2 cubic yards, ready-mix wins decisively on both price and quality. Plant-batched concrete has more consistent strength than site-mixed bags, and the truck does in 20 minutes what would take a crew all day. One more consideration: ready-mix suppliers often have 4-yard minimums, so confirm before you plan around a 2-yard pour.

Cement vs Concrete: Clearing Up the Confusion

Cement and concrete are not the same thing, though the terms get mixed up constantly. Cement is a fine powder made from limestone and clay. It is one ingredient in concrete, acting as the binder that holds everything together. Concrete is the finished building material: cement plus water plus sand plus gravel or crushed stone. When a project calls for "cement bags" at the hardware store, you almost certainly want bags of premixed concrete, not pure cement powder. Pure Portland cement is sold separately but is only useful if you are batching your own mix from raw aggregates, which very few DIYers do. Building a brick wall on top of your new slab? Use our brick calculator to estimate bricks and mortar for the next phase.

Using the Multi-Mode Calculator Above

The calculator at the top of this page handles the four most common concrete project types. For slabs, patios, and driveways, enter length, width, and thickness. For walls, enter the wall length, height, and thickness. For footings, enter the trench length, width, and depth. For columns and sonotubes, enter the diameter, height, and number of columns. Every mode of this concrete calculator outputs cubic yards, total weight, bag counts by size, and an estimated 2026 cost range. The 10% waste factor is included in the bag counts so the number you see is the number to buy.